In the last year, I’ve had mechanic help come in now and then to help out. Between he, I and my shop rat – things start to get out of place with good used parts, new parts, and complete garbage laying around – instead of put away properly. Getting stuff done has taken a priority to organization and putting parts, tools, and supplies away. Currently I’m going through the shop and putting stuff away, and trying to improve organization. Yesterday I spent the first couple of hours putting good parts away, and bad parts in garbage. There was a lot of both. Then I started reorganizing the electrical crash cart, which was a total mess. I got rid of the bad short wires thrown in the cart and wound up good short pieces, sorted and bagged connectors which, somehow got unsorted. I put switches and fuses; shrink tubes and relays; and connectors in cases.
I still have six other crash carts to straighten out, but this was the worst of them. On my stacker, the door cabinet was mounted very low because of some plates I used to mount a puck lock system.
It interfered with the golf cart when loaded. So it got mounted higher today after cutting a relief hole in the back.
Also in the stacker, the aircraft cargo track that got ripped up when I had to lock up the brakes with a car on the lift – had a new one cut, edges ground smooth, bent to fit beaver tail, and screwed down with new screws, lock washers and nuts.
The Magnum has been sitting for a couple of years. Recently the gas was drained, carb rebuilt and car running and tuned before replacing the carpet and seats. It drives great, but brakes were horrible. Originally it was suspected to have been the master cylinder – so that was removed and inspected. It was fine and the brakes bled and adjusted. Brakes still sucked so car was jacked up and both rear wheels still turned while brakes were applied. Since the they bled fine, it is suspected that the pistons are froze up inside from sitting so long – and ones are on the way.
Also in the “spent a lot of time and money fixing the wrong items” department, the hydraulic clutch on my 99 Drifter 1500 motorcycle was slipping. It got replaced last month. Now it has a slight delay engaging. Bleeding didn’t help so I bought a used master cylinder and a rebuild kit as new is made of unobtainium. It was rebuilt and put on, but same issue existed. the slave cylinder was bled, and same thing. The hose between the two was removed. While 150 psi of air was introduced at one end, less than ten psi comes out of the other end – meaning 20 years has degraded the hose and its collapsed. It too is made of unobtainium, so I’ll have to take someplace that can take a hose with banjo fittings.
So a lot of hours were spent wasting time yesterday. Heading to the lake for the weekend, so thrashing resumes next week.